Dungiven Dress Fitting: Full Bust Adjustment (FBA)

Working through a Full Bust Adjustment (FBA) on a dress without darts can be a puzzle to get started! While there are different possible approaches, the simplest one is to treat the bodice like any other, and create a temporary dart where you’d see one on the most “average” FBAs. Then the pleats are used to take up the changes made. 

*the FBA may be accomplished in other ways, and if you have the skills to try a different approach, go for it! This tutorial is not the only way, but the way that we think will be the smoothest workflow for the most sewists. 

Mark cut lines (pink) and hinges (green Xs):

  • An X at the bust apex
  • Vertical line, parallel to the grainline and in between the pleats, from hem edge to bust apex
  • From the side seam, horizontally or angled a bit down, connecting with the apex
  • From the armscye notch to the apex, with the hinge directly on the seamline (not the cut line!)

Cut along the lines, from the hem to the apex, keep on going around the corner to but not through the armscye seam. Then clip into the armscye seam allowance to the hinge. Cut from the side seam on the line to the apex, leaving a hinge at the apex. 

Shift the side portion down and to the side a bit, gently on the hinges. Add paper behind the Front. Mark a parallel line beside the vertical cut line – the distance is half of your total bust adjustment amount. Line up the side portion with the vertical line, allowing the cut line in the side seam to open up and create a new dart. Tape the pieces in place on the top half of the bodice.

Mark a new cut line on the side portion, squared off from the grainline, from the vertical cut line to the side seam.

Cut along the new horizontal cut line and shift the hem portion up, staying aligned with the grainline, until the hem edges are even. 

Add a cut line to the Hem Facing aligned with the Front’s vertical cut line.

Cut on the new line and spread the Hem Facing apart to match the Dress Front. Add paper and tape in place. 

True up the seam lines and cut lines at the side seams and hem edges

Enlarge the pleats. Divide the amount of the fba in to four equal amounts, and increase the pleat size by moving each leg by this amount away from the pleat. (For example: If your fba was 1/2” (1.2 cm), move each leg 1/8”(3 mm) increasing the pleat.)

Closeup of pleats:

And that’s the completed FBA. After a change like this, make sure the Front and Back side seams are the same length, double check that the Hem Facing fits perfectly on the Front, and consider making a muslin to be sure you’re happy with the changes before you cut into the good fabric! 

Happy sewing!

Responses

Your email address will not be published. Required fields are marked *